Home
HS Progarmmable Brushless Controller 25A   $35.99       
Specifications:
Input Voltage: Ni-CD/Ni-MH/6~12V or Li-Po 7.4~11.1V
Output current: 25A: max current 30A, continuous current 25A for 10 minutes
BEC Output: 5V1.5A.2LiPo\4-5mini servo, 3Lipo\3-4mini servo
Dimensions: 50mm x 22mm x 8mm
Weight: 1 oz with connectors         
Features:
  • Automatically detect 2 or 3 cells Li-Po
  • Set BEC voltage for Li-Po at 3.0V per cell
  • Automatically detect Ni-Cd/MH cells
  • Set BEC voltage for Ni-Cd/MH at 0.8V per cell
  • Safe start –will not turn the motor if the throttle is not in the bottom position
  • Temperature protection, auto shut down the motor if the surface temperature reaches 110 DC
  • Lost of control protection, shut down the motor after I second without signal

Program:
  1. Turn on the transmitter, switch throttle stick to the full power position (for some Futaba transmitters,
    the throttle channel shall be reversed).
  2. Connect the receiver and motor.
  3. Connect the battery to the speed controller.
  4. You should hear the following sounds (If there are no more sounds after a long Bee, try to revers the
    throttle channel.
  • Bee: Set Li-Po BEC. Default set up is 3.0V per cell. It will repeat 2 times, if you don't want to change
    this setting, wait for next sound. If you want to turn the BEC off (not recommended), turn the throttle
    stick to the bottom. You will hear a Bee, move the stick back to the full power position for next set up.

  • Bee Bee: Set Ni-Cd/MH BEC. Default set up is 0.8V per cell. It will repeat 2 times, if you don't want to
    change this setting, wait for next sound. If you want to turn the BEC off (not recommended), turn the
    throttle stick to the bottom. You will hear a Bee, move the stick back to the full power position for next
    set up.

  • Bee Bee Bee: Set brake. Default setting is brake off. If you want to turn the brake on, turn the throttle
    stick to the bottom. You will hear a Bee to confirm your setting.